Beeper Settings - PSC PowerScan Programming Manual

Beeper Settings

These labels provide options for the scanner's audible 'beep' signal. Refer-
ence "LED and Beeper Indicator" located in the first section of this manual
for more information about beeper behavior.
Audible Signal—enables/disables the beep upon completion of a good read.
Power-up Beep—when enabled, beeps upon scanner power up.
Beeper Volume—allows setting of the beeper to three different volume
settings. The greatest volume occurs with frequency set high and
volume set to volume 3.
Good Read Beep Duration—can be adjusted to SHORT (100msec),
MEDIUM (250msec), or LONG (500msec) durations.
When to Beep—may be programmed to announce a 'good read' upon
completion of one of the following events:
• Decode of a bar code label
• Transmission from the scanner to the host
• CTS activation at the host terminal (RS-232 interface models ONLY)
SET ---------------------------------
O
FF
O
N
E
NABLE
D
ISABLE
R44-1840
It is strongly recommended that this
feature remain enabled, as the good read
beep provides the best scanning status
feedback to the user. Error tones are
always enabled and cannot be disabled.
----------------------------
-----------------------------
------------------------
-----------------------
NOTE
95