Upc/Ean Add-Ons - PSC PowerScan Programming Manual

UPC/EAN Add-Ons

There are many, many ways to configure the scanner to handle add-ons.
The scanner uses four filters that can be specified to define how add-ons
will be handled. For each filter...
- each add-on type can be disabled, required or optional
- any combination of the four UPC/EAN symbologies can be affected
- 2-digit, 5-digit and C128 add-ons can be individually config-
ured
- the leading digits of the base labels affected can be specified
The settings below represent only a small portion of
the options available for this feature. Contact your
salesman or service provider if you need more assis-
tance with advanced add-on settings.
All add-ons DISABLED, all UPC/EAN symbologies — the
scanner will not recognize or decode any add-on segment of
UPC/EAN labels, and will read and decode the standard
UPC/EAN portion of the label. The following bar codes
affect all four UPC/EAN symbologies, and will be applied to
all labels regardless of the leading digits of the base label.
To reset all four filters to disable all add-ons for all UPC/
EAN symbologies, scan the SET bar code, then all four of
the DISABLE bar codes, then the END bar code on the
next page.
56
NOTE
PowerScan ™ Programming Guide