Code 39 - Continued - PSC PowerScan Programming Manual

Code 39 - continued

Follow these steps to set Code 39 Minimum Label Length:
1. Identify the minimum length setting you want to make. The
selectable range is 00 to 48
2. Scan the SET label.
3. Scan the SET CODE 39 MINIMUM LABEL LENGTH bar
code.
Setting Lengths
If you are setting a length less than ten, you must scan a zero first and
then the length digit ( 04, 06, 08).
4. Set the minimum label length by scanning the correct digits
from below and the next page.
5. Scan the END label.
SET --------------------------------------
S
ET
0 ------------------------------
1 ------------------------------
2 ------------------------------
1 For this symbology, the scanner will decode up to 48 characters, but the actual length read will vary
depending upon interface type, and bar code physical size and quality. Code 39 bar codes
containing one or more full ASCII characters can also limit the amount of characters that will be
decoded (in these circumstances, the scanner will decode at least 24 data characters).
R44-1840
M L L
INIMUM ABEL
1
characters.
ENGTH
63