General Features; Green Led Lamp Idle State - PSC PowerScan Programming Manual

General Features

The following section contains the general features that are common
to all interfaces. These features (shown below in the order listed in
this section) allow modification of the scanner's behavior to
accomodate user preferences.
•

Green LED Lamp Idle State

• Beeper Settings
• Marker Beam Mode
• Read Verification
• Low Power Mode
• AutoSense Stand Mode
Green LED Lamp Idle State
When the scanner is idle, its green LED lamp can be programmed to indicate
this in one of two ways:
• LED lamp is OFF when the scanner is idle.
• LED lamp is ON when the scanner is idle.
SET --------------------------------------
LED
LED
END --------------------------------------
94
OFF ----------------
IS
ON -----------------
IS
PowerScan ™ Programming Guide