PSC PowerScan Programming Manual page 42

These characters will be added to the standard label format when your system
has specific and unique requirements for information added to the bar code
label data before it is sent to the host. Suffix characters follow the label data.
Identify your specific system requirements before adding or modifying these
settings, then...
1. Look at the ASCII chart shown on the inside back cover of this
manual, and identify the ASCII character(s) and the correspond-
ing Hex Code(s) for the ASCII characters you will use as suffixes.
For example, if you are going to send two suffix characters as
'LF' (Line Feed) and 'CR' (Carriage Return). The ASCII chart
shows that 'LF' equals 0A
2. Scan the SET bar code.
3. Scan the SET SUFFIX bar code on this page.
4. Turn to the keypad on the last two pages of this manual, and scan the
four digits corresponding to the Hex Values determined in step 1 above.
For the example in step one, scan 0, A, 0,D.
If you make a mistake, or lose your place while setting this
option, scan the END bar code to exit Programming Mode.
The scanner will sound a two-beep error tone to indicate
that programming was incomplete, and the setting will
remain as it was before entering Programming Mode.
5. Scan the END bar code.
You have added a two character suffix to all bar code data,
regardless of label symbology, that will be added to the label
data before it is sent to the host.
SET --------------------------------------
S
ET
G A
O TO PPENDIX
KEYPAD BEFORE SCANNING THE
38
Setting Universal Suffix(es)
S ------------------
UFFIX
C
OF THIS MANUAL AND SCAN THE APPROPRIATE CHARACTERS FROM THE
END
and 'CR' equals 0D
hex
NOTE
BAR CODE TO EXIT PROGRAMMING SESSION
PowerScan ™ Programming Guide
hex
.