Return To Factory Settings - PSC PowerScan Programming Manual

Return to Factory Settings

Scan this label to return the scanner to the default settings configured at the
factory for your scanner's original interface specifications. This label is
typically used to return the scanner to a "known" operating state when the
present programming status is not known, faulty, or suspect.
SET --------------------------------------
R
ETURN TO
END --------------------------------------
If you don't have a record of your site/system's original configuration,
you may need to call your nearest PSC service depot for assistance to
return the scanner to normal function. Please be prepared to provide
information about the company, location, host terminal system and
other pertinent information about the scanner being repaired.
R44-1840
Use this label with caution, since it will reset
ALL features that may have been pro-
grammed for that interface type since the
scanner’s installation.
If your scanner is a HIGH DENSITY model,
it may not be able to read the factory
settings bar code above. If so, scan
these three bar codes in its place.
F S
ACTORY
WARNING
NOTE
ETTINGS
11