Low Power Mode - PSC PowerScan Programming Manual

Low Power Mode

When enabled, Low Power Mode causes the scanner to power-down
completely between trigger pulls. This results in very low idle current,
lowering the energy needs of the scanner. It does, however, require
the scanner's microcontroller to reboot with every trigger pull. This
will introduce a very small delay in scanning when this mode is
enabled. Therefore, it is recommended that this mode only be used
when the scanner is connected to a battery powered terminal.
SET --------------------------------------
S
TEP
S
TEP
S
TEP
S
TEP
END --------------------------------------
104
IMPORTANT
The state of this feature is not af-
fected by the RETURN TO FACTORY
DEFAULTS programming bar code. It
must be manually enabled or disabled
using the programming bar codes below.
#1------------------------
#2------------------------
#1------------------------
#2------------------------
PowerScan ™ Programming Guide