PSC PowerScan Programming Manual page 41

These characters will be added to the standard label format when your host
system has specific and unique requirements for information added to the bar
code label data before it is sent to the host. Identify your specific system
requirements before adding or modifying these settings, then...
1. Look at the ASCII chart shown on the inside back cover of this
manual, and identify the ASCII character(s) and the correspond-
ing Hex Code(s) for the ASCII characters you will use as
prefixes.
For example, if you are going to send two prefix characters as
'STX' (start transmit) and 'SP' (Space). The ASCII chart shows
that 'STX' equals 02
2. Scan the SET bar code.
3. Scan the SET PREFIX bar code on this page.
4. Turn to the keypad on the last two pages of this manual, and scan the
four digits corresponding to the Hex Values determined in step 1 above.
For the example in step four, scan 0, 2, 2, 0.
If you make a mistake or lose your place while setting this
option, scan the END bar code to exit Programming Mode.
The scanner will sound a two-beep error tone to indicate
that programming was incomplete, and the setting will
remain as it was before entering Programming Mode.
5. Scan the END bar code.
You have added a two character prefix to all bar code data,
regardless of label symbology, that will be added to the label
data before it is sent to the host.
SET --------------------------------------
S
ET
G A
O TO PPENDIX
KEYPAD BEFORE SCANNING THE
R44-1840
Setting Universal Prefix(es)
hex
P ------------------
REFIX
C
OF THIS MANUAL AND SCAN THE APPROPRIATE CHARACTERS FROM THE
END
and 'SP' equals 20
NOTE
BAR CODE TO EXIT PROGRAMMING SESSION
hex
.
37