• Adjustment
Shift cable to clutch control lever
(a) Place shift lever and clutch control lever a in the neutral position.
(b) Push the cable connector 8 and shift cable 4 in the direction shown by the arrow H to remove all
play in the cable.
(c) While pressing against the cable and connector, adjust the connector 8 to align with pivot pin 0 on
the clutch control lever.
(d) When aligned, press the connector 8 (flat side of connector towards the clutch control lever) over
the pivot pin 0.
(e) Install the washer A and snap pin B, then tighten the cable lock nut C against the connector to
maintain adjustment.
(f) Make sure that both forward and reverse gears can be engaged with the same angle of shift lever
travel from "NEUTRAL" position.
View X
x
Tiller handle
model
Remote control
model
PIVOT PIN POSITION
DF40QH / DF50QH
27
D