INSTALLATION
Installation is reverse of removal with special attention to fol-
lowing steps.
Lower tilt rod full down position.
Apply Water Resistant Grease to the tilt cylinder lower shaft
and lower shaft bushes
Install lower shaft and bushes into position in the lower eyelet.
99000-25160 : Water Resistant Grease
Place the PTT unit in position between the clamp brackets.
Tighten the clamp bracket shaft nut to specified torque.
Clamp bracket shaft nut :
Slide the PTT cylinder lower shaft bolt through the clamp bracket
and lower shaft, then secure with the nut.
Apply Water Resistant Grease to tilt rod upper bushes
install bushs in tilt rod.
Operate the PTT motor to extend the PTT rod upward.
Align the tilt rod with the hole in the swivel bracket as the tilt rod
extends.
99000-25160 : Water Resistant Grease
.
43 N . m (4.3 kg-m, 31.0 lb.-ft.)
POWER TRIM AND TILT 8-14
, then