DRIVESHAFT
Slide on the pre-load spring
Assemble the thrust bearing
to the driveshaft.
Lower the driveshaft assembly down into the gearcase until the
bottom of shaft protrudes through center of pinion.
DRIVESHAFT BEARING HOUSING
Apply Water Resistant Grease to the driveshaft oil seal.
99000-25160 : Water Resistant Grease
Install the gearcase seal ring
bearing housing.
Apply Suzuki Silicone Seal to gearcase and driveshaft bearing
housing surfaces.
99000-31120 : Suzuki Silicone Seal
Install complete housing and shift rod assembly on gearcase.
NOTE:
Be sure the stepped section
peller shaft.
Also be sure the rear side of the shift cam (with detent notch ) is
positioned over the detent ball
and secure it with the pin
, washer
and pinion shim
into the groove on the driveshaft
of shift cam faces towards pro-
in the gearcase.
.
Shift cam
LOWER UNIT 9-16