20
DF40QH / DF50QH
MID UNIT
TILLER HANDLE
Functions
The tiller handle is equipped with the following centralized
component parts necessary for proper operation and han-
dling.
1Ignition switch
3Shift lever
5Throttle friction adjust knob
REMOVAL
1. Remove the rigging port grommet 1 from front panel.
Remove both lower side covers.
2. Remove snap pin 2, washer 3 and throttle cable con-
nector 4 from throttle control arm.
Unthread connector from throttle cable.
3. Remove snap pin 5, washer 6 and shift cable connec-
tor 7 from clutch control lever.
Unthread connector from shift cable.
4. Remove cable stopper 8 from between cables.
5. Disconnect handle wire harness connector 9 from en-
gine wiring harness.
2Emergency stop switch
4Throttle control grip
3
4
1
2
5
8