Fujitsu Primergy BX900 System Message Manual page 247
Blade server systems
ethernet connection blade module sb6 / sb11a / sb11 switch and ibp version
Hide thumbs
Also See for Primergy BX900:
- User manual (811 pages) ,
- Hardware reference manual (69 pages) ,
- Configuration manual (67 pages)
Table of Contents
Advertisement
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Error Message
Explanation
Recommended Action
Ports cannot be added to disabled port-channels.
User attempt to add a member to a disabled port-channel.
Enable the port-channel before add member ports.
Ports being added to a port-channel must not be participating in
MAC Filtering.
User attempt to add a interface to a port-channel, but the
interface has been set with MAC filter function.
Use command 'no macfilter addsrc <macaddr>' to remove the
MAC Filter setting first, and then use command 'channel-group
<unit/slot/port>' to add interface to the port-channel.
Could not create. This port-channel name already exists.
User create a port-channel name that already exists.
Use another port-channel name.
[slot/port] is not a configured port-channel.
User try to display the port-channel information for
non-port-channel interface.
Use correct port-channel interface slot/port for this command.
Port-channel name must be less than 16 characters.
User attempt to crate a port-channel name is over 15 characters.
Configure port-channel name within 15 characters.
Incorrect input! Use 'port-channel load-balance all
{dst-ip|dst-mac|src-dst-ip|src-dst-mac|src-ip|src-mac}'.
Incomplete command for this function.
Use complete command 'port-channel load-balance all
{dst-ip|dst-mac|src-dst-ip|src-dst-mac|src-ip|src-mac}'.
Incorrect input! Use 'port-channel name {<logical slot/port> | all}
<name>'.
Incomplete command for this function.
Use complete command 'port-channel name {<logical slot/port> |
all} <name>'.
Port-channel name is too long.
User attempt to rename a port-channel name over 15
characters.
Configure port-channel name within 15 characters.
2011 Fujitsu Technology Solutions
©
Advertisement
Table of Contents
