Fujitsu Primergy BX900 System Message Manual page 109

Severity Level
Error Message
Explanation
Recommended Action
Severity Level
Error Message
Explanation
Recommended Action
Severity Level
Error Message
Explanation
Recommended Action
Severity Level
Error Message
Explanation
Recommended Action
Severity Level
Error Message
Explanation
Recommended Action
Severity Level
Error Message
Explanation
Recommended Action
6
Different type of Connection Blade is detected on stack member
<unit-id>.
Different type of connection blade is detected on stack member.
Remove this mismatched connection blade from the stack or use
command, "switch <unit-id> bootmode <switch|IBP>" to change
the mode to be the same as the stack master.
After the mode is changed via the provided command, the
mismatched connection blade will be reloaded automatically.
1
out of stack members, please pull out the cable and make sure
only maximum 8 units in a stack
The stack member is exceeded max supported number in a
stack.
Remove this connection blade from the stack.
1
Running code version not available, aborting discovery message
send.
Can't find the running code version.
Checking if there is any default booting image in the flash.
1
Flash code version not available, aborting discovery message
send
Can't find the code version in the flash.
Checking if there is any default booting image in the flash.
1
Problem sending discovery message on unit <unit-id>
The discovery messages can't be sent out.
Please check the stacking cable is connected.
1
Failure while attempting to delete management unit
Can't delete the management unit.
Please do not delete the management unit.
2011 Fujitsu Technology Solutions
©