Configure A Dhcp L2 Relay Interface - NETGEAR M7100 Series User Manual

Select the Admin mode Disable or Enable radio button.
8.
For global configuration, this enables or disables the DHCP L2 Relay on the switch. The
default is Disable.
For VLAN configuration, VLAN ID shows the VLAN ID configured on the switch.
9.
a. Use Admin mode to enable or disable the DHCP L2 Relay on the selected VLAN.
b. Use Circuit ID mode to enable or disable the Circuit ID suboption of DHCP
Option-82.
c. Use Remote ID String to specify the Remote ID when Remote ID mode is enabled.
Click the Apply button.
10.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Pagination Navigation Menu
•
Rows per page. Select how many table entries are displayed per screen. Possible
-
values are 20, 50, 100, 200, and All.
If you select All, the browser might be slow to display the information.
Note:
< Display the previous page of the table data entries.
-
> Display the next page of the table data entries.
-

Configure a DHCP L2 Relay Interface


To configure DHCP L2 Relay:
Prepare your computer with a static IP address in the 169.254.100.0 subnet, for
1.
example, 169.254.100.201.
Connect an Ethernet cable from an Ethernet port on your computer to an Ethernet port on
2.
the switch.
Launch a web browser.
3.
Enter the IP address of the switch in the web browser address field.
4.
M6100, M5300, and M7100 Series Managed Switches
Configure System Information
98