D-Link DRO-250i User Manual page 32

Introduction to DRO-250i
connection type he/she selects from the ISDN connections page. User can
select Channel 1(B1) or Channel 2(B2) only when the connection type is
2-64K Dial in. For all other connection types Channel 1(B1) will be
selected automatically. When the user clicks on the Channel 1 or Channel
2 he will get the information which he configured previously for the
particular channel.
Secure:
When ON is selected the Dialin connections are accepted only from the
phone numbers added in the Dialin User Accounts Page. If OFF is
selected then Dialin connections will be accepted from any phone
number.
Local IP:
Enter the IP address to be assigned for the Dialin connection one at end. It
is in the form of four IP octets separated by a dot (x.x.x.x).
Unnumbered:
This interface can be configured as an unnumbered interface.
Netmask:
Enter the subnet mask in dotted decimal (i.e. A.B.C.D) format.
Remote IP
Enter the IP address to be assigned to the remote end for the Dialin
connection. It is in the form of four IP octets separated by a dot (x.x.x.x).
Authentication
Select the PAP or CHAP depending on what the other end is using. Try
PAP/CHAP only when user is not sure what the other end is using.
Idle Timeout (In seconds)
If there is no activity on the line the connection gets disconnected after the
time entered in this field in seconds.
DRO-250i User Manual
31