Status - Log - Black List - D-Link DRO-250i User Manual

Introduction to DRO-250i
3.8.6.5 Status Log Black list
- -
Click on Status > Log > Black list to open the web page as shown below:
The Router firewall is pre-programmed to recognize and block many
commonly used intrusion methods from computers on the WAN
(Internet,) from one computer to another on the LAN, and from computers
on LAN to the WAN. In addition user can define a Port Filter Policy that
will set additional intrusion criteria for the Router firewall to block
connections. When a serious intrusion attempt (i.e. large number of
packets consistent with a commonly used intrusion method) are detected
by the Router the IP address, the protocol used and the corresponding port
number is determined and entered into the Router Intruder Blacklist. Once
the intruder information is entered the Routers firewall will block packets
from this location from crossing the Router (i.e. from the WAN to the
LAN, from two computers on the LAN, or from the LAN to the WAN).
Source IP - The IP address of a computer or device that will not be
allowed to make a connection from the WAN to the Router is displayed
here.
Destination IP - The IP address of the computer or device that the
intruder has tried to connect to is displayed here.
DRO-250i User Manual
123