Tools - Remote Access - D-Link DRO-250i User Manual

Configuring DRO-250i
3.7.7

Tools - Remote Access

Click on Tools > Remote Access to get the web page as shown below:
Remote Access Status Enable/Disable: It allows the user to enable to
disable the entire feature. If user clicks on disable and apply, then it is not
possible to configure the Web remotely.
Remote IP - This is the IP address of the machine or device which can
configure DRO-250i remotely. If NAT is enabled on the remote side, then
the Global IP should be entered here because DRO-250i will get the
request from that Global IP.
If user wants to change any IP-Address and remote access is already
enabled, then user should disable the remote access and enable it again.
After enabling it again, user should change any IP-Address, and then only
it will be effective. If user changes any IP when remote access is enabled,
then other IP addresses will be applied again, and hence user will give a
alert message saying "One of the IP Range already exist". In order to
avoid this warning, please disable the remote access and enable it again
with the new changed IP addresses.
DRO-250i User Manual
108