Toshiba RAV-SM563UT-E Service Manual/Integration page 190

No. Photo / Explanatory diagram
Assembly
Return a set of the refrigeration cycle assembly into the outdoor unit base plate and reassemble sound
3
insulation board, partition plate assembly, fan motor assembly, and side cabinet (R/L) as original. Fix the
thermostat fixing plate to the side cabinet (R), built in the inverter assembly, and then connect various
cables. After then, incorporate front cabinet, upper cabinet, wiring cover, and valve cover as before.
3-1
Thermostat fixing plate
3-2
Do not make cord heater loose.
Do not put the heating part near the electric parts box.
Perform cable process for collected
cord heater and fan motor lead cables.
P-shape
3-3
clamp
Power cord for
cord heater
To keep the lead wires from coming into contact with the
edges of the sheet metal or tips of the screws, wrap the
shield tubes around the leads to protect them and use
the bundling ties to secure them.
3-4 Incorporate front cabinet, upper cabinet, wiring cover, water-proof cover and valve cover as before.
In installation work, connect power cord for the cord heater to another breaker separated from one for
4
power cord of the air conditioner.
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Side cabinet (R)
– 190 –
www.heronhill.co.uk
Procedure
Return a set of the refrigeration cycle assembly into
the outdoor unit base plate, and assemble sound
insulation board, partition plate assembly, fan motor
assembly, and side cabinet (R/L) as original.
Using screws (Self-tapping screw type-B Ø4 × 8mm,
stainless), fix the thermostat fixing plate to the side
cabinet (R).
After incorporating the inverter assembly as before,
furthermore perform cable process for cord heater
and power cord.
For the cord heater, perform cable process so that
there is no looseness or sag at the fan side.
Perform cable process for the cord heater together
with the fan motor lead cable, and collect the re-
mained part of cables at cable process part of the
inverter.
Secure the power cord for the cord heater to the
terminal block mounting plate using the P-shape
clamp, and pull it out from the wiring area of the side
cabinet (R).
* Check that there is the marked part of the cord
heater on the outdoor unit base plate or near it.
When there is the heating part near the electric
parts box, a fire may generate.
Since the lead wires connected to the cord heater
and thermostat may come into contact with the edges
of the sheet metal or tips of the screws, wrap the
shield tubes around the leads to protect them and
use the bundling ties to secure them.
Fax: 01823 665807