Toshiba RAV-SM563UT-E Service Manual/Integration page 133

No. Part name
ˆ
Horizontal 1. Push the louver holder toward arrow
louver
2. Pull off the left and right chaft of
‰
TC, TCJ sensor 1. Remove the drain pan.
2. Remove the set screws (4 positions)
3. Pull out the sensor is inserted into
Š
Heat 1. Take down the main unit and then
exchanger
2. Remove the drain pan.
3. Remove the set screws (6 positions)
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Procedure
direction of right figure, and pull out
the center shaft (SM562, SM802 :
1 position, SM1102, SM1402 :
2 positions) from louver holder.
horizontal louver.
and heat exchanger support.
pipe of the heat exchanger.
treat the heat exchanger on the
floor.
of fixing heat exchanger and main
unit.
– 133 –
www.heronhill.co.uk
Remarks
Louver holder Shaft of
horizontal louver
Screws
(Fixing heat exchanger support)
Heat exchanger Heat exchanger support
Screws
(Fixing heat exchanger and main unit)
Fax: 01823 665807
8 -1
9 -3
10 -3