Toshiba RAV-SM563UT-E Service Manual/Integration page 184

No. Part name Q'ty
13 Power cord 1
14 Thermostat 1
fixing plate
15 PVC tube 1
16 Shield tube 1
17 Bundling tie 1
NOTE: The parts on the above table are recommended parts.
2. Required tools for installation work
No. Part name
1 Plus screwdriver
2 Wrench
3 Motor drill
4 Faston crimping tool
5 Close-end connector
crimping tool
6 Cutting plier
7 Stripper
8 Cutter knife
9 Insulation tape
10 Metal-cutting shears
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Specifications/Vendor
2-cores x 0.75mm² or more, H05RN-F
Material: SGCC-Z08, Board thickness: 0.8t
Inside diameter Ø8 x outside diameter Ø11 x 70 mm
Inside diameter Ø18 x outside diameter Ø26 x 70 mm
Material: Polyethylene foam
Bundling tie for securing the wires
Material: 6/6 nylon
Specifications
It is used for disassembling and assembling of each cabinet.
It is used for disassembling and assembling of compressor fixing nuts.
Drill diameter: It is used to make the additional holes on the base or the side
Ø3.2 and Ø5.0 cabinet (R).
Fixing jig for #250
It is used to process the side cabinet (L).
– 184 –
www.heronhill.co.uk
Remarks
Procured locally
Procured locally
(Drawing attached)
Procured locally
Procured locally
Procured locally
Usage
Fax: 01823 665807