Toshiba RAV-SM563UT-E Service Manual/Integration page 157

No. Part name
Š
1. Detachment
Fan guard
1) Perform the works in 1 of
To prevent damage on the products, treat
component on a corrugated paper, cloth,
etc.
2) Remove the air-outlet cabinet, and then
put down it directing the fan guard side
downward.
3) Take off screws fixing the bell-mouth.
(ST1T Ø4 × 10, 2 pcs)
4) Remove the bell-mouth.
5) Take off screws fixing the fan guard.
(ST1T Ø4 × 10, 2 pcs)
6) Remove hanging hook of the fan guard by
pushing with a minus screwdriver.
2. Attachment
1) Insert the extrusion at the upper side of
the fan guard into the square hole of the
air-outlet cabinet, and then insert the
hanging hook. Fix the hanging hooks
(5 positions) by pushing with hands.
Check that all the hanging hooks are fixed
to the specified positions.
2) After attachment, fix it with screws.
(ST1T Ø4 × 10, 2 pcs)
3) Mount the bell-mouth by hanging hooks
(3 positions) at upper side of the bell-
mouth to the square holes of the air-outlet
cabinet.
4) After attachment, fix it with screws.
(ST1T Ø4 × 10, 2 pcs)
* Caution in assembling bell-mouth
• The size (color) of the bell-mouth at
Upper side: Black
Lower side: Gray
Upper side: Black
Lower side: Black
Tel: 01823 665660
Heronhill - for all your Toshiba requirements
Procedure

REQUIREMENT
REQUIREMENT
upper side differs from that at lower side.
(Only for RAV-SP1102AT-E)
<In case of RAV-SP1102AT-E>
<In case of RAV-SP1402AT-E>
– 157 –
www.heronhill.co.uk
‚
and in 1 of .
Minus screwdriver
Hanging hook
Bell-mouth
Hooks (3 positions)
Remarks
Air-outlet
cabinet
Bell-mouth
Screws
(2 pcs)
Remove
Bell-mouth
Air-outlet cabinet
Fan guard
Air-outlet cabinet
Square holes (3 positions)
Fax: 01823 665807