Table of Contents
Advertisement
The following table contains instructions on how to configure your Prestige for Internet access.
FIELD
ISP's Name
Enter the name of your Internet Service Provider. This information is
for identification purposes only.
Encapsulation
Press [
your ISP. Choices are PPPoE, PPPoA, RFC 1483 or ENET ENCAP.
Multiplexing
Press [
your ISP. Choices are VC-based or LLC-based.
VPI #
Enter the Virtual Path Identifier (VPI) assigned to you.
VCI #
Enter the Virtual Channel Identifier (VCI) assigned to you.
ATM QoS Type
Press [SPACE BAR] and select CBR (Continuous Bit Rate) to specify
fixed (always-on) bandwidth. Select UBR (Unspecified Bit Rate) for
applications that are non-time sensitive, such as e-mail. Select VBR
(Variable Bit Rate) for bursty traffic and bandwidth sharing with other
applications.
Peak Cell Rate
This is the maximum rate at which the sender can send cells. Type
(PCR)
the PCR.
Internet Access
Menu 4 - Internet Access Setup
ISP's Name= MyIsp
Encapsulation= ENET ENCAP
Multiplexing= LLC-based
VPI #= 8
VCI #= 32
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
My Login= N/A
My Password= N/A
ENET ENCAP Gateway= N/A
IP Address Assignment= Dynamic
IP Address= N/A
Network Address Translation= SUA Only
Address Mapping Set= N/A
Press ENTER to Confirm or ESC to Cancel:
Figure 26-6 Menu 4 Internet Access Setup
Table 26-2 Menu 4 Internet Access Setup
DESCRIPTION
SPACE BAR
] to select the method of encapsulation used by
SPACE BAR
] to select the method of multiplexing used by
Prestige 660W/HW Series User's Guide
EXAMPLE
MyIsp
ENET ENCAP
LLC-based
8
32
UBR
0
26-5
Advertisement
Chapters
Table of Contents
