Timeout; Figure 13-5 Adding/Editing Source And Destination Addresses; Table 13-4 Adding/Editing Source And Destination Addresses - ZyXEL Communications Prestige 660W Series User Manual

Prestige 660W/HW series User's Guide

Figure 13-5 Adding/Editing Source and Destination Addresses

The following table describes the labels in this screen.

Table 13-4 Adding/Editing Source and Destination Addresses

LABEL
Address Type Do you want your rule to apply to packets with a particular (single) IP address, a
range of IP addresses (e.g., 192.168.1.10 to 192.169.1.50), a subnet or any IP
address? Select an option from the drop-down list box that includes: Single Address,
Range Address, Subnet Address and Any Address.
Start IP Address Type the single IP address or the starting IP address in a range here.
End IP Address Type the ending IP address in a range here.
Subnet Mask Type the subnet mask here, if applicable.
Apply Click Apply to save your changes back to the Prestige.
Cancel Click Cancel to return to the previously saved settings.

13.7 Timeout

The fields in the Timeout screens are the same for Local Network to Internet Set and
Internet to Local Network Set, so the discussion below refers to both.
13-12
DESCRIPTION
Creating Custom Rules