In this case, only one set of VPI and VCI numbers need be specified for all protocols. The valid range for the
VPI is 0 to 255 and for the VCI is 32 to 65535 (1 to 31 is reserved for local management of ATM traffic).
27.5.3 Advance Setup Options
In menu 11.1, select PPPoE in the Encapsulation field.
Rem Node Name= MyISP
Active= Yes
Encapsulation= PPPoE
Multiplexing= LLC-based
Service Name=
Incoming:
Rem Login=
Rem Password= ********
Outgoing:
My Login= ?
My Password= ?
Authen= CHAP/PAP
Move the cursor to the Edit Advance Options field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.8 – Advance Setup Options.
The following table describes the fields in this menu.
Remote Node Configuration
Menu 11.1 - Remote Node Profile
Press ENTER to Confirm or ESC to Cancel:
Figure 27-9 Menu 11.1 Remote Node Profile
Menu 11.8 - Advance Setup Options
PPPoE pass-through= No
Press ENTER to Confirm or ESC to Cancel:
Figure 27-10 Menu 11.8 Advance Setup Options
Prestige 660W/HW Series User's Guide
Route= IP
Bridge= No
Edit IP/Bridge= No
Edit ATM Options= No
Edit Advance Options= Yes
Telco Option:
Allocated Budget(min)= 0
Period(hr)= 0
Schedule Sets=
Nailed-Up Connection= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 0
27-11