Pre-Operation Inspection; Checking Engine Oil - Shindaiwa DGK180FP Operator's Manual

8. Pre-Operation Inspection

WARNING : INJURY
 Do not open the check door when the power switch is turned and the main power is
on. It will cause injury by rotating parts such as cooling fans and fan belt.
 Always press power switch to turn off the main power and stop the engine, then close
and lock OPERATION PANEL DOOR before checking or maintaining the engine or
any equipment.
CAUTION : BURNS
 Do not touch the engine and surrounding components immediately after stopping the
engine as they are still extremely hot.
CAUTION : FIRE
 Always be sure to wipe up any spilled fuel or oil.

8-1. Checking Engine Oil

To check the engine oil, keep the equipment in leveled position, remove the oil level gauge
and wipe so that no oil remains, and then re-insert the dipstick fully. Prior to starting the
engine, make sure to fill the engine oil through the oil filler until it reaches the MAX line.
< Note >
 Wait approximately five minutes or more after stopping the engine or adding oil before
checking the oil level again.
 An accurate oil level reading cannot be obtained if the generator is not placed in leveled
position.
 Do not overfill with oil to avoid engine damage.
Oil Level Gauge
Oil Filler
(1) Types of Engine Oil
Use only API service-type CJ-4 class.
(2) Engine Oil Viscosity Grades
Use a diesel engine oil with an appropriate viscosity corresponding to the ambient
temperature (refer to the table).
Oil Level Gauge
MAX
MIN
39
Not
Too
OK Enough
Much
：Oil Level