Table of Contents
Advertisement
TROUBLESHOOTING
The sound suddenly
goes off.
The protection circuitry has been activated
Check that the speaker impedance setting is correct.
because of a short circuit, etc.
Check that the speaker wires are not touching each
other and then tum this unit back on.
12
Sound is heard from
the speaker on one
side only.
The sleep timer has turned off this unit.
The sound is muted.
Incorrect cable connections.
Incorrect settings in "SPEAKER
LEVEL".
Tum on this unit, and play the source again.
Press MUTE or VOLUME +/- on the remote control
to resume audio output.
Connect the cables properly.
If
the problem persists,
the cables may be defective.
Adjust the "SPEAKER LEVEL" settings.
30
17-23
76
Only the center
speaker outputs
substantial sound.
When playing a monaural source with a
CINEMA DSP program, the source signal
is directed to the center channel, and the
front and surround speakers output effect
sounds.
One of the HiFi DSP programs (except for
Try another sound field program.
6ch Stereo) has been selected.
No sound is heard
from the center
speaker.
No sound is heard
from the surround
speakers.
No sound is heard
from the subwoofer.
86
"CENTER" in "SET MENU" is set to
"NONE".
"SUR. LR" in "SET MENu" is set to
"NONE".
This unit is in the "STRAIGHT" mode
and a monaural source is being played
back.
"BASS OUT" in "SET MENU" is set to
"FRNT" when a Dolby Digital or DTS
signal is being played.
"BASS OUT" in "SET MENU" is set to
"SWFR" or "FRNT" when a 2-channel
source is being played.
The source does not contain low-
frequency bass signals.
Set "CENTER" to "SML" or "LRG".
Set "SUR. LR" to "SML" or "LRG".
Press STRAIGHT (EFFECT) on the front panel so
that "STRAIGHT" disappears from the front panel
display.
Set "BASS OUT" to "SWFR" or "BOTH".
Set "BASS OUT" to "BOTH".
75
59
75
35
75
75
Advertisement
Table of Contents
