Table of Contents
Advertisement
CONNECTIONS
Both FM and AM indoor antennas are supplied with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to
designated terminals.
2
Press and hold the tab of the AM ANT
terminal.
• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
• A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality,
install an outdoor antenna. Consult the nearest authorized
YAMAHA dealer or service center about outdoor antennas.
3
Insert one of the AM loop antenna lead wires
into the AM ANT terminal.
Indoor FM antenna
(supplied)
AM loop antenna
(supplied)
Release the tab of the AM ANT terminal back
into place.
4
Ground
For maximum safety and
minimum interference,
connect the antenna GND
terminal to a good earth
ground. A good earth
ground is a metal stake
driven into moist earth.
Outdoor AM antenna
Use a 5 to 10 m (16.4 to 32.8
ft)
of
vinyl-covered wire extended outdoors
from a window.
•
Connecting the AM loop antenna
1
Set up the AM loop antenna.
5
Repeat steps 2 through 4 to connect the
other lead wire to the GND terminal.
,I,
~<i>~
Once you have properly connected the AM loop antenna to
this unit, orient the AM loop antenna for the best reception
when you tune into AM stations (see page 41).
22
Advertisement
Table of Contents
