CONNECTIONS
•
Connecting the speaker cable
1
Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
•
Connecting the banana plug
The banana plug is a single-pole electrical connector
widely used to terminate speaker cables.
Banana plug
10 mm (0.4 in)
I
..
1
Tighten the knob.
2
Loosen the knob.
Red: positive (+)
Black: negative (-)
3
Insert one bare wire into the hole on the side
of each terminal.
Red: positive (+)
Black: negative (-)
4
Tighten the knob to secure the wire.
Red: positive (+)
Black: negative (-)
14
2
Insert the banana plug connector into the
end of the corresponding terminal.