Yamaha HTR-5935 Owner's Manual page 87

REMOTE CONTROL FEA TURES
While holding down CODE SET, press one of
the input selector buttons to select the
component you want to set up.
You can control other components by setting the
appropriate remote control codes. You can set the remote
control codes for each input source. For a complete list of
available remote control codes, refer to "LIST OF
REMOTE CONTROL
CODES'~
at the end of this manuaL
The following table shows the default component
(Library: component category) and the remote control
code for each input source.
1
CODE SET
~
While holding
down
+
CO MD/CD-R XM
0 0
0
DVD DTV/CBL OVR V-AU X
~ooo
Remote Control Code Default Settings
CD CD
YAMAHA
199
MD/CD-R CD-R YAMAHA
499
TUNER
TUNER YAMAHA
Fixed
*1
XM TUNER YAMAHA
899
DVD DVD YAMAHA
699
DTV/CBL
*2
DVR
V-AUX
*1
You can control this unit only.
*2
You can only set TV remote control codes in DTV/CBL.
You may not be able to operate your YAMAHA component even
if a YAMAHA remote control code is initially set as listed above.
In this case, try setting other YAMAHA remote control codes.
You need to hold down CODE SET throughout this procedure.
2
While holding down CODE SET, press the
numeric buttons (O to 9) to enter the three-
digit remote control code for the component
to be used.
When the setting succeeds, "PRESET OK" appears;
however, when it does not, "PRESET NG" appears in
the front panel display. Refer to "LIST OF REMOTE
CONTROL CODES" at the end of this manuaL
While holding
down
CODE SET
~+
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• You can only assign one remote control code to each input
selector button.
83