Table of Contents
Advertisement
USING OTHER FEA TURES
Use this feature to select the component connected to the
MULTI CH INPUT jacks (see page 21) as the input
source.
Press MULTI CH INPUT on the front panel (or
MULTI CH IN on the remote control) so that
"MULTI CH INPUT" appears in the front panel
display.
When this unit is in the "STRAIGHT" mode, 2-channel
stereo sources are output from only the front left and right
speakers. Multi-channel sources are decoded straight into
the appropriate channels without any additional effect
processing.
1
Press AMP and then press STRAIGHT on the
remote control to select "STRAIGHT".
When "MULTI CH INPUT" is shown in the front panel display,
no other source can be played. To select another input source with
the INPUT selector on the front panel (or one of the input selector
buttons), press MULTI CH INPUT (or MULTI CH IN on the
remote control) so that "MULTI CH INPUT" disappears from the
front panel display.
+
STRAIGHT
~
+
2
To deactivate the "STRAIGHT" mode, press
STRAIGHT on the remote control again so
that "STRAIGHT" disappears from the front
panel display.
The sound effect is turned back on.
Remote control
................
11.1:
I I :
I
.e.
i-·ir··
i..':
i
or
+
i·.·ii
Ii
··S···i-
•.... ;
i
i·ii.. .!!.... i
. s .
= ...
·r··i
MULTI CH
INPUT
~
Front panel
,I,
~(j)~
You can also select "STRAIGHT" by pressing STRAIGHT
(EFFECT) on the front panel.
You can mix down multi-channel sources to 2 channels
and enjoy playback in 2-channel stereo.
Press AMP and then press STEREO on the
remote control repeatedly to select "2ch Stereo".
+
STEREO
~
+
~'c¥~
• You can use a subwoofer with this program when "BASS OUT"
is set to "SWFR" or "BOTH" (see page 75).
• You can also select "2ch Stereo" by pressing the
PROGRAM
-<l /
C>
buttons on the front panel.
35
Advertisement
Table of Contents
