Ribbon Take-Up Hub & Clutch Assembly - Datamax I-class Maintenance Manual

Removal and Replacement
3. Rotate the Ribbon Supply Hub until the Pin engages the Notch in the Housing.
Housing
Ribbon
Supply Hub
Nylon
Washer
Notch
Pin
4. Secure the Ribbon Supply Hub to the Housing with the Metal Washer and Screw.
5. Reinstall the Thermal Transfer Assembly; see Section 4.5.
4.5.2 Ribbon Take-up Hub & Clutch Assembly
Removal:
1. Remove the Thermal Transfer Assembly; see Section 4.5.
2. Remove the E-Ring from the Take-Up Hub shaft and then remove the Inner Bearing.
3. Remove the Take-Up Hub and the Outer Bearing from the Thermal Transfer Housing.
4. Slightly compress the Take-Up Hub Clutch then remove it from the Thermal Transfer Housing.
4-16