Datamax I-class Maintenance Manual page 52

Displayed Message
TEMPERATURE
FAULT
TOP OF FORM FAULT
Troubleshooting
Fault Messages (continued)
Description
Turn OFF the printer. Then, when cooled, turn ON the
printer. If the problem persists, it can be due to one
of following reasons:
A high printhead 1) The location may be too hot; move the printer to a
temperature has
caused a shutdown.
2) Enter DIAGNOSTICS / SENSOR READINGS then
Press the FEED Key then proceed accordingly:
If media moves –
1) The media may be improperly loaded, or calibration
TOF was not
detected within the
2) Sensor positioning may be required, or the
maximum label
length setting, or a
TOF was
unexpectedly
3) The Media Sensor may need cleaning (see Section
detected.
4) The Leveling Cam may be improperly set; adjust it
Note: When the

SENSOR TYPE is
REFLECTIVE, this
5) The label's length may be longer than the
fault is given for
an out of stock
condition.
7) The Media Sensor may be defective; replace it (see
Solution
place that does not exceed 100°F (38°C) ambient.
examine the THR value: If 000 or 255, the
Printhead or Printhead Cable may be defective (see
Section 4.4).
may be needed; reload then calibrate (see Section
2.1).
SENSOR TYPE may be incorrect; check the position
and setting.
2.4.3).
(see Section 2.2.1).
MAXIMUM LABEL LENGTH; check and if needed
adjust the setting.
Section 4.7).
-continued next page-
3-14