Replacement:
1. Position the Power Supply PCB in the printer then secure it with the four Screws.
2. Place the Washer onto the Screw, and then secure the Ground Wire Lug to the chassis with the
Screw.
3. Position the Nut Plate over the AC Connector and then secure the AC Connector and the Nut Plate
to the chassis with the two Screws.
4. Reconnect the cables to the Power Supply PCB.
5. Verify the correct Printhead supply voltage; see Section 2.2.4.
4.11
Main Logic PCB
Removal:
1. Turn OFF and unplug the printer.
2. Disconnect the interface cable(s) from the Main Logic PCB.
Removal and Replacement
4-27