Getting Started; Plugging In And Starting The Phone - Aastra 6735i User Manual

Getting Started

The 6735i and 6737i must be set up and be configured prior to its first use. This section describes phone behavior and start
up screens you may see when the phone is first plugged in, or when it is restarted.

Plugging in and Starting the Phone

If your System Administrator used the auto install process, you might be prompted to enter the Device ID when you start
the phone. Enter the Device ID provided by your administrator, and then select Done. Select Yes to continue the installa-
tion. The configuration file is created and the phone restarts.
The phone automatically begins the start up sequence as soon as it is connected. The phone goes through this process the
first time you plug in your phone and every time you restart your phone.
The phone displays a series of startup screens similar to the following.
15%
LLDP
The phone then checks settings and looks for new configuration and firmware updates for the phone from a server. If a
new update is found, the phone displays the message Updating Config. This may take a few moments while the phone
downloads the latest updates.
Note:
New updates to your phone can be automatically scheduled from the server. This is set up on the phone system by your
System Administrator and should be scheduled during non-business hours or slow call periods.
6735i/6737i User Guide for Clearspan – 2862-002 – September 2014
DHCP: Waiting for IP
45%
Updating config
0%
20%
Auto Discovery...
Skip
50%
Checking for firmware
Do not unplug phone!
Getting Started
30%
3