Park/Pickup; Phone Lock Key - Aastra 6735i User Manual

session. This is called Group Paging on the IP phones. Your System Administrator can also specify group paging RTP
addresses that the phone listens for when receiving RTP streams. Your administrator can specify up to five listening multi-
cast addresses.
For more information about Group Paging and how it works, and to specify multicast addresses, see
page 50.
The following procedure describes the use of the Paging key on the IP Phone. The procedure assumes your System
Administrator has already configured the Paging key.
Notes:
• Recipient of a Paging call can set a global Do Not Disturb (DND) to ignore any incoming pages.
• For incoming Paging, the phone uses the Intercom configuration settings. The incoming Page is dependent on the
Allow Barge-In parameter setting and the Idling/On Call state.
1. On the IP Phone, press the softkey, programmable key, or expansion module key configured for Paging (labeled as
Group 1 in the following illustration).
The phone opens a multicast RTP session and an outgoing OR incoming phone screen displays as follows.
2. Press the Drop key to end the multicast RTP session and return to the idle screen.
Note:
If you enable global DND on the phone, the incoming multicast RTP session is dropped.

Park/Pickup

The Park and Pickup keys allow you to park a call and retrieve it from another phone. For more information, refer to
"Parking and Picking Up Calls"

Phone Lock Key

Your System Administrator can configure a key on the IP Phone to use as a lock/unlock key, assigning the function of the
key as Phone Lock.
After an lock/unlock key is configured, refer to the following procedures to use the key on the IP phone.
6735i/6737i User Guide for Clearspan – 2862-002 – September 2014
L1 John Smith
01/01/14 11:00am
Group 1
LAB
ACD
L1 John Smith
Paging
Drop
on page 19.
Line Keys, Programmable Keys, and Softkeys
00:01
"Group Paging" on
43