Aastra 6735i User Manual page 30
Sip ip phones
Hide thumbs
Also See for 6735i:
- User manual (219 pages) ,
- Release notes (45 pages) ,
- Quick reference manual (19 pages)
Table of Contents
Advertisement
Options Menu
Use the following procedures to configure ring tones and tone sets on the IP phone.
1.
Press
on the phone to enter the Options list.
2.
Select Preferences.
3.
Select Tones.
4.
Select Ring Tone.
5.
Select the type of ring tone (Tone 1 through Tone 5, or Silent).
6.
Press Done.
7.
Select Tone Set.
8.
Select the country for which you want to apply the tone set. The default is US.
9.
Press Done. The ring tone and tone set you select is immediately applied to the IP phone.
Contrast Level
The Contrast Level option on the IP phone allows you to set the amount of light that illuminates the LCD display. Use
this option to set the preference of contrast level.
1.
Press
on the phone to enter the Options list.
2.
Select Preferences.
3.
Select Display.
4.
Select Contrast Level.
Use the 3 and 4 navigation buttons to increase or decrease the intensity of contrast lighting on the LCD.
5.
6.
Press Done to save your selection.
Backlight
The Backlight option on the IP phone allows you to set the backlight status on the LCD display to the following:
•
Off - Backlight is always OFF.
•
Auto (Default)- Automatically turns ON the backlight when the phone is in use, and then automatically turns OFF the
backlight when the phone is idle after a specified length of time.
Auto backlighting sets the phone to turn off the backlighting after a period of inactivity; the idle period is user definable
under the Advanced softkey when you select the Auto mode. In Auto mode, the backlight turns on with a key press or
state change on the phone.
1.
Press
on the phone to enter the Options list.
2.
Select Preferences.
3.
Select Display.
4.
Select Backlight.
Use the 5 and 2 navigation buttons to select the Backlight status for your phone. Available options are Off or Auto.
5.
The default is Auto.
6.
If you selected Off, press Done to save your setting.
7.
If you selected Auto, press the Advanced softkey. Using the keypad, enter the amount of seconds you want the phone
to stay backlit when the phone is idle. Valid values are 1 to 7200 seconds. Default is 600 seconds (10 minutes). When
this period of time is reached, the phone turns OFF the backlight.
8.
Press Enter to save your setting.
24
6735i/6737i User Guide for Clearspan – 2862-002 – September 2014
Advertisement
Table of Contents
