Configuring Igmp Mroute - Proxy; Enabling Igmp Ssm-Map; Configuring Igmp Ssm-Map Static - D-Link xStack DGS-3610 Series Configuration Manual

DGS-3610 Series Configuration Guide
interface will judge the member information maintained itself is connected from the interface
with mroute-proxy. Hence, the configuration of proxy-server is equal that this interface only
executes the host behavior, but not executes the router behavior. Execute the following
commands in the interface mode:
Command
DGS-3610(config-if) # ip igmp
proxy-service
35.6.11 Configuring IGMP MROUTE -
PROXY
After this command is configured, the interface can forward packets to corresponding uplink
interface.
After corresponding uplink interface is configured as the proxy-server interface, this interface
can forward various igmp protocol packets sent by its members. Execute the following
commands in the interface mode:
Command
DGS-3610(config-if)# ip igmp mroute-proxy

35.6.12 Enabling IGMP SSM-MAP

When this command is configured, the dynamic learned group information will be added into
the related source record message forcibly. This command is usually used together with the
ip igmp ssm-map static command.
Execute the following command in the interface mode:
Command
DGS-3610(config)# ip igmp ssm-map
enable
35.6.13 Configuring IGMP SSM-MAP
STATIC
This command is used together with the ip igmp ssm-map enable command. After this
command is configured, the received message under v3 will be mapped into the
corresponding source record.
Execute the following command in the interface mode:
Chapter 35 IP Multicast Routing Configuration
Function
Configure it as the proxy-server status on the
interface.
Function
Configure it as the mroute-proxy status on the
interface.
Function
Enable the ssm-map function globally.
35-19