Rip Configuration Examples; Example Of Configuring Split Horizon - D-Link xStack DGS-3610 Series Configuration Manual

Chapter 27 RIP Routing Protocol Configuration
To forbid or allow some interface to receive the RIP packet, execute the following command
in the interface configuration mode:
Command
DGS-3610(config-if)# no ip rip receive enable
DGS-3610(config-if)# ip rip receive enable
To disable or allow some interface to receive the RIP message, execute the following
command in the interface configuration mode:
Command
DGS-3610(config-if)# no ip rip send enable
DGS-3610(config-if)# ip rip send enable

27.3 RIP Configuration Examples

This section provides two RIP configuration examples:

Example of Configuring Split Horizon


Example of configuring RIP unicast update packets

27.3.1 Example of Configuring Split Horizon

Configuration requirements:
There are five devices. Where, RouterA, RouterD and RouterE are connected via the
Ethernet; RouterA, RouterB and RouterC are connected via the frame relay. Figure
27-1shows IP address distribution and equipment connection, where RouterD is configured
with a sub-address.
27-8
DGS-3610 Series Configuration Guide
Function
Forbid the interface to receive the RIP packet.
Allow the interface to receive the RIP packet.
Function
Forbid the interface to send the RIP
message.
Allow the interface to send the RIP message.