Configuring Default Gateway For Client; Configuring Address Lease Period; Configuring Domain Name Of Client - D-Link xStack DGS-3610 Series Configuration Manual

Chapter 20 DHCP Configuration
Command
DGS-3610(dhcp-config)# bootfile filename
20.5.6 Configuring Default Gateway for
Client
The configured default gateway for the client will be used as the default gateway parameter
that the server assigns to the client. The IP address of the default gateway must be in the
same network as the IP address of the DHCP client.
To configure the default gateway of the client, execute the following command in the address
pool configuration mode:
Command
DGS-3610(dhcp-config)# default-router
address
[address2...address8]
20.5.7

Configuring Address Lease Period

The lease for the address that the DHCP server assigns to the client is usually one day. The
client should request to renew when the lease period is going to expire. Otherwise, this
address cannot be used when the lease period expires.
To configure the address lease period, execute the following commands in the address pool
configuration mode:
Command
DGS-3610(dhcp-config)# lease {days [hours]
[ minutes] | infinite}
20.5.8

Configuring Domain Name of Client

The domain name of the client can be specified, so that the domain name suffix will be
automatically added to the incomplete host name to form a complete host name when the
client accesses the network resources using the host name.
To configure the domain name of the client, execute the following command in the address
pool configuration mode:
Command
DGS-3610(dhcp-config)# domain-name
domain
20-6
DGS-3610 Series Configuration Guide
Function
Configure the name of the client boot file
Function
Configure the default gateway
Function
Configure the address lease period
Function
Configure the domain name