Viewing The Enable Status Of Storm Control - D-Link xStack DGS-3610 Series Configuration Manual

Chapter 36 Port-Based Flow Control Configuration
Command
DGS-3610(config-if)# storm-control
{broadcast | multicast | unicast}
[{ level percent | pps packets |
rate-bps]
In the interface configuration mode, you can disable the storm control of the appropriate
interface by executing the no storm-control broadcast, no storm-control multicast, or
no storm-control unicast commands.
The following example enables the multicast storm control on GigabitEthernet 0/1 and set
the allowed rate to 4M.
DGS-3610#
DGS-3610(config)#
DGS-3610(config-if)#
DGS-3610(config-if)# end
Caution
36.1.3 Viewing the Enable Status of Storm
Control
To view the storm control status of the interface, execute the following command:
Command
DGS-3610# show storm-control
[interface-id]
The instance below shows the enabled status of the storm control function of interface Gi1/3:
DGS-3610# show storm-control gigabitEthernet 0/3
Interface Broadcast Control Multicast Control Unicast Control action
GigabitEthernet 0/3 Disabled Disabled
You can also view the enabling status of the storm control function of all interfaces at a time:
DGS-3610# show storm-control
Interface Broadcast Control Multicast Control Unicast Control Action
--------- ------------------ ------------------ ------- ------- ------
GigabitEthernet 0/1
36-2
configure terminal
interface GigabitEthernet
storm-control multicast
The reference bandwidth for the level-based storm control is the
maximum bandwidth supported by the physical interface, but not
converted from the bandwidth of the physical interface in service.
Disabled
Function
broadcast: Enable the broadcast storm control function.
multicast: Enable the unknown multicast storm control
function.
unicast: Enable the unknown unicast storm control function.
percent: Set according to the bandwidth percentage, for
example, 20 means 20%
packets: Set according to the pps, which means packets
per second
Rate-bps: rate allowed
0/1
4096
Function
Show storm control information.
Disabled none
Disabled Disabled
DGS-3610 Series Configuration Guide
none