D-Link xStack DGS-3610 Series Configuration Manual page 449

DGS-3610 Series Configuration Guide
Command
ipv6 ospf process-id area
area-id [instance-id
instance-id]
ipv6 ospf network {broadcast |
non-broadcast | point-to-point |
point-to-multipoint
[non-broadcast]} [instance-id
number
ipv6 ospf cost cost [instance-id
number
ipv6 ospf hello-interval seconds [instance-id number]
ipv6 ospf dead-interval seconds [instance-id number]
ipv6 ospf transmit-delay seconds
[instance-id number]
ipv6 ospf retransmit-interval
seconds [instance-id number]
ipv6 ospf priority number
[instance-id number]
To disable the configuration, use the prefix command no before the command above.
Chapter 34 OSPFv3 Configuration
Function
Configure the interface to participate in
the OSPFv3 routing process.
Set the network type of an interface.
The default is the broadcast network
type.
(Optional) Define the cost of an
interface.
(Optional) Set the time interval to send
the Hello packet on an interface.
For all nodes in the whole network, the
vale must be the same.
(Optional) Set the adjacency
dead-interval on an interface.
For all nodes in the whole network, the
vale must be same.
(Optional) Set link-state
retransmit-interval.
(Optional) Set the LSA transmit delay
on an interface.
(Optional) Set the priority of an
interface. The priority is used to select
Designated Routers (DR) and Backup
Designated Routers (BDR).
34-7