Ospf Trap Sending Configuration; Monitoring And Maintaining Ospf - D-Link xStack DGS-3610 Series Configuration Manual
Hide thumbs
Also See for xStack DGS-3610 Series:
- Quick installation manual (6 pages) ,
- Hardware installation manual (26 pages)
Table of Contents
Advertisement
Chapter 28 OSPF Routing Protocol Configuration
By default, all interfaces are allowed to receive/send the OSPF packets. To re-enable the
network interface to send the route information, you can use the no passive-interface
interface-id command. To set all network interfaces, use the keyword default.
28.2.17 OSPF TRAP Sending Configuration
The protocol defines several types of the OSPF TRAP, such TRAP information is used to
send the TRAP information to snmp-server when part of the network configuration changes
and some OPSF event occurs for the network management. In the global configuration
mode, you can enable the TRAP sending switch of OSPF by the following steps:
Command
DGS-3610# configure terminal
DGS-3610(config)# snmp-server
host host-ip version
version-no string [ospf]
DGS-3610(config-router)#
snmp-server enable traps ospf
DGS-3610(config-router)# end
DGS-3610# write
By default, the device will not send the TRAP information to any snmp-server. At present, our
product can only control the sending condition of all OSPF TRAPs by this switch, but can not
accurately control whether it will send the specified type of the OSPF TRAP.
28.3 Monitoring and Maintaining
OSPF
You can show the data such as the routing table, cache, and database of the OSPF. The
following table lists some of that data that can be shown for your reference.
Command
DGS-3610# show ip ospf [process-id]
28-20
DGS-3610 Series Configuration Guide
Meaning
Enter the global configuration mode.
Configure the snmp-server to receive the TRAP.
host-ip refers to the address corresponding to
the server. version-no refers to the snmp version
corresponding to the server. String is usually the
communication authentication code of snmp,
which
is
generally
public.
parameter ospf refers to snmp-server receive
the OSPF TRAP (by default, the server receives
all types of TRAPs).
Enable the sending switch of OSPF TRAP
Return to the privileged EXEC mode.
Save the configuration.
Meaning
Show the general information of the OSPF
protocol for corresponding processes. It will
display all processes if the process number is
not specified.
The
optional
Advertisement
Table of Contents
