Ip And Mac Address Binding; Overview; Configuring Address Binding; Viewing The Address Binding Table - D-Link xStack DGS-3610 Series Configuration Manual

DGS-3610 Series Configuration Guide
DGS-3610# show mac-address-table notification history
History Index:1
Entry Timestamp: 15091
MAC Changed Message :
Operation
---------- ---- -------------- --------------------
Added
Removed
History Index:2
Entry Timestamp: 21891
MAC Changed Message :
Operation
----------- ---- ------------- --------------------
Added

13.3 IP and MAC Address Binding

13.3.1

Overview

Through configuring the binding function of IP and MAC address, you can control the filtering
to the input packets. If you bind a specified IP address with a MAC address, the swith only
receives the packets binding address matched both with the source IP address and MAC
address; otherwise this packet will be discarded.
You can strictly control the legality check of the input source for the device by adopting the
characteristic of binding with the address. To be noted that the control of switch input through
address binding has priority over 802.1X, port-based security and ACL.
13.3.2

Configuring Address Binding

In the global mode, you can set address binding by performing the steps below:
Command
DGS-3610(config)# address-bind
ip-address mac-address
DGS-3610(config)# address-bind
install
To cancel the binding for IP and MAC address, use the no address-bind ip-address
mac-address command in the global configuration mode.
Disable the binding function by executing the commanc no address-bind install.
13.3.3

Viewing the Address Binding Table

To show the address binding table for IP and MAC address, use the show address-bind
command in the privilege mode:
VLAN MAC Address Interface
1 00d0.f808.3cc9 Gi1/1
1 00d0.f808.0c0c Gi1/1
VLAN MAC Address Interface
1 00d0.f80d.1083 Gi1/1
Chapter 13 MAC Address Configuration
Function
Configure the binding of IP address and MAC
address
Eable the binding function to take effect
13-9