Configure The Allowed Communication Protocol In Line; Configure The Access Control List In Line - D-Link xStack DGS-3610 Series Configuration Manual

Chapter 3 LINE Mode Configuration
3.2.3 Configure the allowed communication
protocol in LINE
To limit the allowed communication protocol type in the LINE, this command can be used for
the configuration. By default, the VTY type allows the communication of all protocols, while
the other types of TTY do not allow the communication of any protocol.
Command
configure terminal
Line vty line number
transport input {all | ssh | telnet | none}
no transport input
default transport input
3.2.4 Configure the access control list in
Line
To configure the access control in line, the command can be used. By default, there is no
configuration of access control list in line. That is, all connections are accepted and all
egress connection are allowed.
Command
configure terminal
Line vty line number
access-class access-list-number {in | out}
no access-class access-list-number {in |
out}
3-2
DGS-3610 Series Configuration Guide
Description
Enter the configuration mode
Enter the Line configuration mode
Configure the allowed communication protocol
in the corresponding Line
Configure forbidding the communication of any
protocol in Line
Restore the communication protocol to default
in Line
Description
Enter the configuration mode
Enter the Line configuration mode
Configure the access control list in
corresponding Line
Cancel the configuration of the access control
list in Line