Enabling Switches In Log System; Enabling Log Statistics; Enabling The Sequential Number Switch Of Log Information; Configuring The Log Information Displaying Level - D-Link xStack DGS-3610 Series Configuration Manual

Chapter 50 Log Configuration
50.2.4

Enabling Switches in Log System

By default, the system name is not included in the log information. To add or remove the
system name in the log information, perform the following commands in the global
configuration mode.
Command
DGS-3610(config)# no service sysname
DGS-3610(config)# service sysname
50.2.5

Enabling Log Statistics

By default, the log statistics function is disabled. To enable or disable the log statistics
function, perform the following commands in the global configuration mode.
Command
DGS-3610(config)# no logging count
DGS-3610(config)# logging count
50.2.6 Enabling the Sequential Number
Switch of Log Information
By default, the log information has no sequential number. To add or delete sequential
number in log information, run the following command in the global configuration mode:
Command
DGS-3610(config)# no service
sequence-numbers
DGS-3610(config)# service
sequence-numbers
50.2.7 Configuring the Log Information
Displaying Level
To limit the number of log packets displayed on different devices, you can set the severity
level of log information allowed to be displayed on those devices.
To configure the log information displaying level, run the following command in the global
configuration mode:
50-4
DGS-3610 Series Configuration Guide
Function
Cancel the system name from the log packet.
Add the system name for the log packet.
Function
Disable the log statistics function and delete the
statistics information
Enable the log statistics function
Function
Delete sequential number in the log messages
Add sequential number in the log messages