Supported Vlan; Vlan Member Type; Configuring Vlan; Saving The Vlan Configuration Information - D-Link xStack DGS-3610 Series Configuration Manual

Chapter 8 VLAN Configuration
device must be used for communication between VLANs. DGS-3610 series can perform IP
routing between VLANs through the SVI (Switch Virtual Interfaces). For the configuration
about the SVI, please see Interface Management Configuration and Configuring IP Unicast
Routing Configuration.
8.1.2

Supported VLAN

The VLAN that the product supports complies with the IEEE802.1Q standard, and supports
up to 4094 VLANs (VLAN ID 1-4094), where VLAN 1 is the default VLAN that cannot be
deleted.
Caution
8.1.3

VLAN Member Type

You can determine the frames that can pass a port, and the number of VLANs that the port
belongs to by configuring the member type of the port in the VLAN. See the following table
for the details of the VLAN member type:
VLAN Member Type
Access
Trunk (802.1Q)
8.2

Configuring VLAN

One VLAN is identified by its VLAN ID. In the device, you can add, remove, and modify
VLAN 2-4094. VLAN 1 is created by the device automatically and cannot be deleted.
You can configure the VLAN member type of a port, or add, or remove a VLAN in the
interface configuration mode.
8.2.1 Saving the VLAN Configuration
Information
You can enter the copy running-config startup-config command in the privileged mode to
save the VLAN configuration information into the configuration file. To view the VLAN
configuration information, use the show vlan command.
8-2
The DGS-3610 series devices support 4094 VLANs.
VLAN Port Feature
One Access port belongs to only one VLAN, which must be
specified manually.
By default, one Trunk port belongs to all the VLANs of the device,
and it can forward the frames of all the VLANs. However, you can
impose restriction by setting an allowed VLAN list
(allowed-VLANs).
DGS-3610 Series Configuration Guide