D-Link xStack DGS-3610 Series Configuration Manual page 227

DGS-3610 Series Configuration Guide
To set the IP MTU value, use the following command in interface configuration mode:
Command
DGS-3610(config-if)# ip mtu bytes
DGS-3610(config-if)# no ip mtu
19.2.2.5 Configuring IP Source Routing
Our product supports IP source routing. When the router receives the IP dato packets, it will
check the Strict Source Route, Loose Source Route and Record Route of the IP header.
These options are described in RFC 791. If one of these options enabled in this data packet,
it performs the appropriate reply action. If it detects a packet with an invalid option, an ICMP
parameter problem message will be sent to the source of the packet and discards the packet.
Our product supports IP source routing by default.
To enable IP source routing, execute the following command in interface configuration mode:
Command
DGS-3610(config)# ip source-route
DGS-3610(config)# no ip source-route
Chapter 19 IP Address and Service Configuration
Function
Set the MTU value with the range 68~1500.
Restore the default setting
Function
Enable IP source routing
Disable IP surce routing
19-13