KYMCO ZX Service Manual page 127

12
. FRAME COVERS
The installation sequence is the reverse of removal.
*
When removing the battery, first
disconnect the battery negative (-) cable
and then the positive (+) cable.
FRONT TOOL BOX REMOVAL
Remove the rear carrier. ( ð 12-5)
Remove the frame body cover. ( ð 12-5)
Remove the floor board. ( ð 12-3)
Remove the front right and left lower covers.
( ð 12-3)
Remove the three bolts attaching the front tool
box.
Remove the front tool box
The installation sequence is the reverse of removal.
BOTTOM COVER REMOVAL
Remove the right and left side rails. ( ð 12-3)
Remove the front cover. ( ð 12-3)
Remove the front right and left lower covers.
( ð 12-3)
Remove the three bolts attaching each side of the
bottom cover.
Remove the bottom cover.
The installation sequence is the reverse of removal.
MET-IN BOX REMOVAL:
Open the seat.
Remove the two bolts, two nuts and the center
bolt attaching the met-in box.
Remove the oil tank cap and rubber packing.
Remove the met-in box.
The installation sequence is the reverse of
removal .
*
Do not allow flames or sparks near the
working area.
Bolts
Front Tool Box
Bolts
Bottom Cover
Rubber Packing
Met-in Box
Bolt Bolts
FRAME BODY COVER REMOVAL
Remove the met-in box. ( ð 12-4)
Remove the three bolts attaching the rear carrier.
Remove the rear carrier.
Remove the frame body cover.
The installation sequence is the reverse of removal.
ZX / SCOUT
Bolt
Floor Board
Front Tool Box
Oil Tank Cap
Nuts
12-4