Cleaning; Cleaning The Charger Wire - Kyocera FS FS-1920 Operation Manual

Cleaning

Cleaning the Charger Wire

To avoid print quality problems, the following printer parts must be
cleaned with every toner container replacement. In addition, the charger
wire and paper transfer unit should be cleaned from time to time, or
whenever print quality problems occur.
If the toner container was replaced when Replace toner Clean
printer was displayed, Clean printer Press GO will appear after
replacement. After cleaning the inside of the printer following the
Note
procedure shown below, press the GO key; the message will disappear
and the printer will be ready for printing.
The charger wire is a part in the drum unit that needs to be periodically
cleaned. You can clean the charger wire by pulling the cleaning knob as
instructed below.
1
Open the left cover on the left side of the printer.
2
Pull the cleaning knob (blue colored) slowly in and out a few times.
This cleans charger wire inside the printer.
Cleaning Knob
(Blue)
Left Cover Charger Unit
3-9
Cleaning